Atop-technology EH7510 User manual Manual do Utilizador descarregar pdf (Página 104)

Atop Industrial Managed Ethernet Switch

EH7510

User Manual V 1.0

Fig. 3.4

3.4.1 Administration Setup using Serial Console

This section shows how users can see administration information and make changes using

command. Detailed explanations of each technical term can be found in Chapter 2 of this

manual.

Table 3.2

Command

Description

sntp <IP-add> <before-utc | after-utc>

<0 ~ 24 hours>

Starts SNTP service.

[no] dhcp

Enable or disable DHCP.

show dhcp

Shows DHCP status.

ip address<ip-addr> <ip-mask>

Set IP address and subnet mask.

Ip default-gateway <ip-addr>

Set the gateway IP address

show ip

Show IP address, subnet mask, and the default

gateway.

Boot

Use this command to reboot the switch.

Show running-config

Display the running configurations of the switch.

copy running-config startup-config

Backup the switch configurations.

erase startup-config

Reset to default factory settings at next boot time.

Show arp

Show the IP ARP translation table.

Ping ip-addr <1~999>

Send ICMP Echo-Request to network host.

<1 ~ 999> specifies the number of repetitions.

Exec

Switch to shell mode. Shell mode may do shell

command.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 119 120

Sem comentários

Atop-technology EH7510 User manual Manual do Utilizador Página 104